Mid Joint Aluminium Panel Trim UV Board Wall Protection Decoration Tile Corner

Application

This trim is designed for use when two panels meet on an internal corner, at a right angle. This trim is 2400mm in length and is available in bright silver. The trim is aluminium and is compatible only with 10mm panels. Trim is 10mm thickness.


Feature

Extruded aluminum with durable finish.

Aluminum Trim outside corner,Aluminum Trim inside corner,Aluminum Trim flat divider,Aluminum Trim edge molding 8' length.

Paint & Powder Coating: BS 6496 (1984)

Specification for powder organic coatings for application and stoving to aluminium alloy extrusions,sheet and pre-formed sections for external architectural purposes, and for the finish on aluminium alloy extrusions, sheet and preformed sections coated with powder organic coatings.

Use

Mill finish (untreated)

External applications

When used externally mill finish aluminium requires regular cleaning to maintain a relatively good standard of appearance. The frequency and cleaning method suggested is dependent on the local environmental conditions.If a cleaning programme is adopted from outset, the surfaces concerned will respond to the following treatment:

• Remove any grease or oil deposits with organic solvent such as white spirit.

• Swab down with a diluted solution of mild detergent followed by rinsing with clean cold water.To retain a reasonable surface appearance, frequency of cleaning will vary from once or twice a year in rural areas;to three or four times per year in mild industrial areas; to once monthly in severely polluted or marine environments.Cleaning long established but neglected installations of aluminium will probably require one or more of the following methods, depending on the severity of the surface contamination.

• Bristle brush and dilute detergent e.g. Fairy Liquid

• Polishing compounds e.g. Brasso

• Nylon pad impregnated with abrasives e.g. Scotchbrite

• Steel wool in conjunction with dilute detergent

Specification

    Our factory operates 18 modern extrusion production lines, with world-class casting equipment, and oxidizing electrophoresis equipment. The whole on-site manufacturing process includes billet casting, mould design, aluminum extrusion, finishing and packaging. The extrusion quality has been confirmed and received high respect. With the management of a full set of quality-control system, we have gained many quality system certificates, including ISO9001 certificate.